About
Two partners, one office, one number to call.
What matters commercially is the structure. Design happens in-house in AutoCAD, so the person drawing your kitchen is the person who has measured your room. We are not tied to one factory: once the drawing is signed off, the boards, shutters and hardware are ordered from the manufacturers best suited to the job, to that exact specification. Our own carpenters then build and fit it.
That matters because most of what goes wrong in this trade happens at a handover between parties. Here those handovers are ours to manage, not yours. You deal with us from the first drawing to the last fitting, and we deal with the manufacturers.
- Warranty
- 10 yrsWarranty
- Ply carcass, every kitchen
- BWPPly carcass, every kitchen
How we work
The whole sequence, with honest durations.
- 01
First conversation
Same day
A call or WhatsApp exchange to understand the property, the rooms in scope and roughly what you want to spend. If we are not the right fit for the budget, we would rather say so now than after a site visit.
- 02
Site measurement
Within a few days
We measure the space ourselves rather than working from the builder's drawing, which is rarely accurate to the centimetre. Beams, window swings, gas and water points, switchboard positions and floor level all get recorded.
- 03
3D design
3–5 days
The room is modelled in AutoCAD to your real dimensions and presented as 3D views from where you will actually stand, with dimensioned elevations for each run.
- 04
Revisions and sign-off
As long as you need
We change the drawing as many times as it takes. Moving a shutter on screen is free; moving it after fabrication is not. Nothing is cut until you have approved the final set.
- 05
Quotation and schedule
2–3 days
An itemised quote naming the ply grade, the finish and the hardware brand and series — not a single lump sum. It comes with a stage-wise schedule and a payment plan tied to milestones rather than dates on a calendar.
- 06
Sourcing to the drawing
1–3 weeks
Once the drawing is signed off, the boards, shutters and hardware are ordered to that exact specification from the manufacturers we work with. Not being tied to one factory means each part comes from whoever does it best at your budget.
- 07
Installation and handover
3–10 days on site
End of processOur own carpenters build and fit from the approved drawing. Everything is adjusted and checked against it, and we walk you through the finished job before handing over. If anything needs attention later, you call us — not a manufacturer you have never met.
Where we do not cut corners
The ply is the decision that outlives the design.
Trends change and a shutter finish can be replaced. A swollen carcass cannot — it has to come out. Through a Gorakhpur monsoon the humidity sits heavy for weeks, and moisture-resistant board drinks it, swells at the edges and starts shedding laminate by the second summer.
So every kitchen we deliver is built on a BWP plywood carcass — boiling water proof, a full grade above the BWR board most quotes stop at — whatever the shutter finish on top. It is not the cheapest quote you will get. It is the reason the kitchen still closes properly in year five.
Hardware is named by brand in every quote — Hettich, Hafele, Godrej, Olive and Ozone — rather than described as “imported”. Boards and shutters come from Dynasty and Makwana. You should be able to look up what you are paying for.
- Carcass
- BWP plywood, every kitchen
- Shutters
- HDHMR, laminate to lacquered glass
- Hardware
- Hettich · Hafele · Godrej · Olive · Ozone
- Design
- AutoCAD 3D, in-house
- Sourcing
- Dynasty · Makwana
- Build & fit
- Our own carpenters
- Contact
- One point of contact throughout
- Warranty
- 10 years
Come and see